DPABI/DPABISurf/DPARSF

Dear experts,

I tried to preprocess my resting state data with DPARSFA version 4.3_170105 in MATLAB 2015a. I get the following error: "error using DPARSFA_run>(parfor body) (line 4088) Reference to non-existent field 'ROIDefForEachSubject'.

Attached is the screenshot. I searched the forums, and I saw the suggestion that this might happen if you don't click the Define ROI button. However, I did click the button and defined the ROIs, by navgating to them in the window that popped up, and made sure the paths to mask files were correct.

各位老师：

       您好，我把电子版的 User Agreement 发到邮箱 maps@rfmri.org， 显示无法发送，不知是什么原因，麻烦啦

Dear Dr. Yan,

I used the 90*90 FC matrix to calculate the topological metric-Modularity on the GRETNA. Several results can be obtained , but I dont kown their meaning: "community_index_All_Node", "participant_coefficient_All_Node", and "size_of_maximum_component". The author of GRETNA did not explain the meaning of these measurments in the Mannual. Could you help me? 

Thanks very much!

Dear experts and Pro. Yan:

                                                  when I look my results in DPABI Viewer, the colorbar only showed the color in the upper amd lower ends. However,  it did not have any color in the middle of colorbar. I do not know how to set the colorbar manual? Or, anyone know that how to load the colorbar from the mat file. Can you send it to me? my email is:1316289208@qq.com

 Thank you very much!

Dear Dr. Yan,

When I was computing CWAS, I found data should be resample  to voxel size of isotorpic 4mm. But after all preprocessing, all data had changed to 4D which can't be resliced by dpabi's function "Image Reslicer" correcttly.

Or can I set the voxel size to [4 4 4] in Normalize step directly and skip the last resample after all preprocessing? Looking forward to your reply. Thanks in advance!

Hongru

1. Open DPABI_VIEW, and load your images and setup.

Hi, Dr. Yan, When I regressed covariates of 200 subjects using latest DPARSF,  an error was shown as below. However, it was fine when I computed just two subjects.

Hi,Chaogan,

I came across an error when I was using CWAS in DPARSF2.3, How to solve this problem?

Looking forward to your reply. Thank you in advance.

Hello everyone,

Hi everyone!

I'm trying to run a single subject rsfmri analysis. I run DPARSF and get my 2 zFC maps , one for each of the 2 sessions (pre and post treatment). The maps look good in the viewer! I put these 2 zFC maps in the stat analysis tool by selecting a paired t test modality, in order to to get a comparison-t-map between the two. Is this right so far? The stat analysis tool look running fine and provide me with a map. However, this map cannot be seen in the viewer. When trying to upload it, matlab provides me with the following error: